NPS 300 Service Bodies:

• Tray to be approx. 4.100m x 2.200m wide.
• Tray to be fitted with space between cab to allow easy access & storage for fire extinguishers x 2.
• Front cross tray box with tope compartment.
• Front left steps with door built into tray.
• Left side box 1900mm long x 1000mm high x 600mm wide with 4 doors.
• Right side bottom box to be 1800mm long x 650 mm high x 550mm wide, this box to have three doors. (as per 550 trucks).
• The right box is to have a chainsaw box on top with a vent fitted.
• Right side ladder rack to carry two long ladders and one short ladder.
• Combination Pintal hook towbar fitted to rear.
• Sliding vice fitted on pullout slide.
• Spotlights fitted to headboard.
• 130 maxilift Crane fitted with 24volt power-pac and manual wind-down leg.
• Tie points fitted to floor for tying down loads.
• Revolving light fitted to headboard.
• Supply and fit one steel Bullbar.
• Supply and fit 12 volt, 12 000lb electric winch, with wire rope and fair lead, hydraulic winches optional.
• Fit winch to front of truck and test.

Service Body for Isuzu 300:

• Body to be approx. 4.000m x 2.000m x 1.6m high.
• Sides to have two liftup doors, with two locks each door and gas struts fitted.
• Rear door to also lift up as per sides.
• Two compartments to have fixed shelves the other two to have four pullout drawers on metal sliding tracks, multi ball type.
• The drawers would be approx. 150mm deep.
• Holder for spotlight pole both sides.
• Special lights fitted, but supplied by CRS.
• Ten interior lights fitted inside and on doors.
• Body fitted to supplied chassis.
• Mounting brackets for aerials fitted to front of body.
• LED rear taillights fitted to rear of body.
• Fit towbar, Haymond Reese type to rear of truck.
• Mudguards and flaps fitted to body as per RTA specifications.
• Internal hooks and tiepoints fitted as required.
• Body sandblasted and painted 2-pac paint (white).